Fluke Networks FI2-7000 FiberInspector Pro

End-face contamination is a leading cause of fiber failures. Dirt and contaminants cause insertion loss and back-reflection that inhibits optical transmission and causes havoc with transceivers. Fiber loss and OTDR testing can expose this problem, but in many cases, dirty connections make fiber testing time consuming and inaccurate. Since dirt can be an issue before, during, or after fiber optic certification testing, and migrate from one end-face to another upon mating, both sides of any connection must always be cleaned and inspected. Further, mating contaminated connectors can cause permanent damage as microscopic debris is crushed between end-faces in physical contact. Even factory terminated patch cords or pigtails must be inspected as protective caps do not keep fiber optic connector end-faces clean. Avoiding this common cause of failure, starts with inspecting the fiber optic connector end-face and eliminating any contamination before insertion into a bulkhead or piece of equipment. The FI-7000 FiberInspector Pro is a fiber optic inspection scope that allows you to inspect and certify end-faces in 2 seconds so you can get the job done the first time. This fiber optic inspection scope provides automated PASS/FAIL certification taking the guess work out of fiber inspection so anyone can be a fiber expert.

• Automated Pass/Fail certification of fiber optic connector end-faces
• Graphical indication of problem areas due to contamination, pits, chips, and scratches
• Certify to industry standards—IEC 61300-3-35
• Eliminate human subjectivity from end-face measurements
• Save fiber optic connector end-face views during certification process
• Versiv modular design supports copper certification, fiber optic loss, OTDR testing and fiber end-face inspection